OPA2835 VFB amplifiers are an industry leading power-performance rail-to-rail amplifier used in battery powered portable applications.
By Texas Instruments 901
OPA835 VFB amplifiers from TI have ultra-low power and an industry leading power-performance ratio for rail-to-rail amplifiers.
By Texas Instruments 796
TI's OPA2188 series are zero-drift operational amplifiers that have very low offset and drift, low quiescent current, and low bias current.
By Texas Instruments 894
A small, low-cost 36 V general purpose operational amplifier with features that help simplify BOM lists for a number of designs.
By Texas Instruments 680
TI's 36 V op amp offers a the best combination of low cost and features that meet the demands for a variety of industrial applications.
By Texas Instruments 756
Output expanders have a wide VCC range of 1.65 - 3.6 V, making it an ideal solution for portable applications.
By Texas Instruments 776
Single-bit noninverting bus transceivers have a fully configurable, dual-rail design that allows each port to operate over a full power supply range.
By Texas Instruments 727
TI's combines a differential driver and a receiver to create a component with a bus port for full-duplex communications for industrial applications.
By Texas Instruments 748
SN65HVD82D is made up of robust drivers and receivers that can be used in demanding industrial applications.
By Texas Instruments 678
TCA6416A series of I/O expanders have a wide VCC range allowing it to interface with next-generation microprocesors and MCUs on the SDA/SCL side.
By Texas Instruments 914
TI's 20 W audio amps are highly efficient, allow a nearly seamless integration process, and accept a wide range of input data and data rates.
By Texas Instruments 1010
THS4531 features include ultra low-power and fully-differential architecture make it compatible for low-power and data acquisition systems applications.
By Texas Instruments 594
SMOMAPL138B applications processor is a low-power applications processors that features a dual core SoC and a LCD controller.
By Texas Instruments 733
I/O expanders have an operating power-supply range of 1.65 V to 3.6 V, making them well-suited for providing general-purpose remote I/O expansion.
By Texas Instruments 2023
TLK110 transceivers are designed for power-supply flexibility, allowing data to be transmitted and received on standard twisted-pair cables.
By Texas Instruments 1276
TI's TMP709 temperature switch has a temperature threshold accuracy of ±0.5°C with a maximum of ±3°C (+60°C to +100°C).
By Texas Instruments 847
TLV3201 comparators have a small package but offer features such as high-speed, low-power consumption, rail-to-rail inputs, and large over drive current.
By Texas Instruments 775
Features a small foot print, a very accurate low 25 mV current sense threshold, and decreases lower levels of power loss.
By Texas Instruments 900
TPS40422 buck controllers are dual-output PMBus synchronous buck controllers but can also be used for a single, two-phase output.
By Texas Instruments 1388
An ultra-small load switch that is controlled by an on/off input that interfaces directly with low-voltage control signals.
By Texas Instruments 1634